Cisco WAP200 Administration Guide

5
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 15
Getting Started
The Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and
Rangebooster works right out of the box with the default settings. However, you
can change these settings using the WAP200 web-based configuration utility.
Before You Begin
Before you begin to use the WAP200 web-based configuration utility, make sure
that you have a computer that meets the following requirements:
• Internet Explorer (version 6 or later) or Mozilla Firefox.
• Your computer is connected to the same network as the WAP200. By
default, the WAP200 access point has an IP address of 192.168.1.245 and a
default mask of 255.255.255.0.
Accessing the Web-Based Configuration Utility
To access the WAP200 configuration utility, follow these steps:
STEP 1 Start a web browser. In the Address bar, enter the default IP address of the
WAP200: 192.168.1.245.
STEP 2 When the login page appears, enter the user name and password.
The default user name is admin.
The default password is admin. Passwords are case sensitive.
STEP 3 Click OK.

Cisco WAP200 Specifications

General

Networking standards	IEEE 802.3af, IEEE 802.11b, IEEE 802.11g
Supports ISDN connection	No
DHCP client	Yes
DHCP server	-
Security algorithms	WEP, WPA, WPA2
Dimensions (WxDxH)	170 x 195 x 205 mm
Storage temperature (T-T)	20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Wi-Fi standards	802.11g, 802.11b
Top Wi-Fi standard	802.11g
Ethernet LAN (RJ-45) ports	1
Product color	Gray

Weight and Dimensions

Weight	400 g