Cisco WAP200 Administration Guide

Getting Started
Navigating the Web-Based Utility
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 16
5
Navigating the Web-Based Utility
The web-based utility consists of the following five main windows:
• Setup
• Wireless
• AP Mode
• Administration
• Status
Additional windows branch out from these main windows.
For a basic network setup, you may only need to use the following windows of the
web-based configuration utility:
• Setup—Enter your basic network settings.
• Management—Click Administration > Management and create a new
password to replace the default password (admin).
• Wireless—To change the default SSID, click Wireless > Basic Settings
and make the necessary changes. To change the level of security, click
Wireless > Security and make the necessary changes.
Setup
This window allows you to configure the host name and IP address settings and to
set the time through the following windows:
• Basic Setup—Configures the Host Name and IP Address settings for this
access point.
• Time—Sets the time either manually, or automatically from a time server if
the access point can access the public internet.

Cisco WAP200 Specifications

General

Networking standards	IEEE 802.3af, IEEE 802.11b, IEEE 802.11g
Supports ISDN connection	No
DHCP client	Yes
DHCP server	-
Security algorithms	WEP, WPA, WPA2
Dimensions (WxDxH)	170 x 195 x 205 mm
Storage temperature (T-T)	20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Wi-Fi standards	802.11g, 802.11b
Top Wi-Fi standard	802.11g
Ethernet LAN (RJ-45) ports	1
Product color	Gray

Weight and Dimensions

Weight	400 g