Cisco WAP200 - Chapter 1: Introduction

1
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 1
Introduction
Thank you for choosing the Cisco WAP200 Wireless-G Access Point with Power
Over Ethernet and Rangebooster.
This access point lets you connect Wireless-G (802.11g) or Wireless-B (802.11b)
devices to your wired network so you can add computers to the network
wirelessly.
The WAP200 also offers the convenience of Power over Ethernet (PoE) capability,
so it can receive data and power over a single Ethernet network cable. You can
even connect wired networks in two different buildings, by using two access
points set to Wireless Bridge mode.