Cisco WAP200 Administration Guide

6
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 19
Configuring the WAP200 Access Point
This chapter describes how to configure your Cisco WAP200 Wireless-G Access
Point with Power Over Ethernet and Rangebooster using the web-based
configuration utility. Configuration is not required if you wish to use the access
point right out of the box with its default settings.
This chapter includes the following sections:
• Setting Up Your Access Point, page 20
• Configuring Wireless Settings, page 24
• Configuring the Access Point’s Modes of Operation, page 50
• Configuring Security Monitor Settings, page 55
• Configuring Administration Settings, page 59
• Verifying Access Point Status, page 69
• Using Windows Help Menus, page 74

Cisco WAP200 Specifications

General

Networking standards	IEEE 802.3af, IEEE 802.11b, IEEE 802.11g
Supports ISDN connection	No
DHCP client	Yes
DHCP server	-
Security algorithms	WEP, WPA, WPA2
Dimensions (WxDxH)	170 x 195 x 205 mm
Storage temperature (T-T)	20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Wi-Fi standards	802.11g, 802.11b
Top Wi-Fi standard	802.11g
Ethernet LAN (RJ-45) ports	1
Product color	Gray

Weight and Dimensions

Weight	400 g