Cisco WAP200 - Configuring WPA2-Enterprise

Configuring the WAP200 Access Point
Configuring Wireless Settings
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 35
6
Configuring WPA2-Enterprise
This option features WPA2 used in coordination with a RADIUS server for client
authentication.
NOTE Use WPA2-Enterprise only when a RADIUS server is connected to the access
point.
To configure the WPA2-Enterprise wireless security settings for the access point,
follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WPA2-Enterprise.
STEP 3 To enable wireless isolation across SSIDs select Enabled from the drop-down
menu. Otherwise select Disabled.
STEP 4 To enable wireless isolation within SSID, select Enabled from the drop-down
menu. Otherwise select Disabled.