Configuring the WAP200 Access Point
Configuring the Access Point’s Modes of Operation
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 52
6
You may alternately wish to change the access point’s mode of operation if you
want to use the access point as a wireless bridge. For example, you can use two
access points in the Wireless Bridge mode to connect two wired networks that
are in two different buildings.
Switch Switch
Wired LAN Wired LAN
Wired LAN Wired LAN
194852
Switch Switch
WAP200 Access
Point Wireless
Bridge
Mode
WAP200 Access
Point Wireless
Bridge
Mode
WAP200 Access Point
Wireless Bridge
Mode
To Next Page
Loading...
