Cisco WAP200 - Page 76

Configuring the WAP200 Access Point
Verifying Access Point Status
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 70
6
To check local network status, follow these steps:
STEP 1 Click Status > Local Network.
The Status > Local Network window displays the status information of the access
point.
• Information
- Hardware Version—Version of the access point’s current hardware.
- Software Version—Version of the access point’s current software.
- Local MAC Address—MAC address of the access point’s LAN interface.
- System Up Time—Length of time the access point has been running.
• Local Network
- IP Address—Access point’s IP address, as it appears on your local
network.
- Subnet Mask—Access point’s subnet mask.
STEP 2 To update the status information, click Refresh.