Citrix ADC MPX Series User Manual

Citrix ADC MPX
Output:
1 RAID1 status: READY
2 Drive:
3 1 ONLINE
4 2 ONLINE
5 Done
Replace a solid-state drive
Replacement solid-state drives (SSDs) contain a pre-installed version of the Citrix ADC soware and a
generic configuration file (ns.conf), but they do not contain SSL-related certificates and keys, or cus-
tom boot settings. Configuration files and customized settings must be restored to a replacement
drive from a backup storage location at the customer site, if available. The files to be restored might
include:
• /flash/nsconfig/ns.conf: The current configuration file.
• /flash/nsconfig/ZebOS.conf: The ZebOS configuration file.
• /flash/nsconfig/license: The licenses for the Citrix ADC features.
• /flash/nsconfig/ssl: The SSL certificates and keys required for encrypting data to clients or to
back-end servers.
• /nsconfig/rc.netscaler: Customer-specific boot operations (optional).
To replace a solid-state drive:
1. At the Citrix ADC command prompt, exit to the shell prompt. Type:
shell
2. Shut down the Citrix ADC appliance by typing the following command at the shell prompt:
shutdown ‒p now
3. Locate the SSD on the back panel of the appliance. Push the safety latch of the drive cover to the
right or down, depending on the platform, while pulling out on the drive handle to disengage.
Pull out the faulty drive.
Note: The illustration in the following figures might not represent the actual Citrix ADC appli-
ance.
Figure 7. Remove the existing solid-state drive
© 1999-2019 Citrix Systems, Inc. All rights reserved. 101

Citrix ADC MPX Series Specifications

General

Type	Application Delivery Controller
Memory	Up to 256 GB
Power Supply	Redundant
Product Series	MPX
Ports	10/25/40/100 Gbps Ethernet
Operating System	Citrix ADC
Management	Citrix ADM
Form Factor	Rack-mountable