Citrix ADC MPX Series - Page 40

Citrix ADC MPX
*The FIPS Management Port (Level 3 Mode) is reserved for a future release.
Caution: Do not insert a USB device into the FIPS Management Port. This will cause the FIPS card to
fail.
Depending on the model, the appliance has the following ports:
• FIPS Management Port (reserved for a future release).
• RS232 serial Console Port.
• Two 10/100/1000Base-T copper Ethernet Management Ports (RJ45), numbered 0/1 and 0/2 from
le to right. These ports are used to connect directly to the appliance for system administration
functions.
• Network Ports
– MPX 9700/10500/12500/15500. Eight copper or fiber 1G SFP ports numbered 1/1, 1/2, 1/3,
and 1/4 on the first row from le to right, and 1/5, 1/6, 1/7, and 1/8 on the second row from
le to right. Eight 10/100/1000BASE-T copper Ethernet Ports (RJ45) numbered 1/9, 1/10,
1/11, and 1/12 on the third row from le to right, and 1/13, 1/14, 1/15, and 1/16 on the fourth
row from le to right.
– MPX 9700/10500/12500/15500 10G and MPX 9700/10500/12500/15000 FIPS. Two 10G SFP+
Ports numbered 10/1 and 10/2 on the top row, eight 1-gigabit copper or fiber 1G SFP Ports
numbered 1/1, 1/2, 1/3, and 1/4 on the middle row from le to right, and 1/5, 1/6, 1/7, and
1/8 on the bottom row from le to right.
Important: The 10-gigabit ports on this appliance are labeled 10/1 and 10/2.
The following figure shows the back panel of the MPX 9700/10500/12500/15500 appliances, including
the 10G model and FIPS model.
Figure 4. Citrix ADC MPX 9700/10500/12500/15500, MPX 9700/10500/12500/15500 FIPS, and MPX
9700/10500/12500/15500 10G, back panel
© 1999-2019 Citrix Systems, Inc. All rights reserved. 40