295
INJECTION
CHECKS: TURBO PRESSURE
Tools.
[1] Pressure gauge for checking boost pressure : 4073-T.A Kit 4073-T
[2] Sleeve for checking boost pressure : 4185-T
[3] Adaptor sleeve : 4229-T
Checks.
IMPERATIVE: respect the following checking requirements: Engine at running temperature.
Vehicle in running order at full load.
Preparation.
Remove the collar fixing (3).
Insert the tool [2] connected with tool [3], between the pipe (1) and the duct (2).
Position tool [1] in the vehicle.
Connect the sleeve [2] to the tool [1] with its tube «a».
Procedure.
Start the engine.
Engage first gear and start the engine.
Engage the gears up to third gear.
Decelerate to 1000 rpm.
Accelerate hard, and check the pressure: 0.6 ± 0.05 bar
(1500 rpm)
.
Accelerate freely in kick-down
(changing from fourth to third gear)
.
Check the pressure: 0.95 ± 0.05 bar
(between 2500 and 3500 rpm)
.
Remove the tools, reposition the pipe (1) and refit the collar (3).
B1HP12JD
Engine: RHZ
XSARA PICASSO
To Next Page
Loading...
