CITROEN C8 2005 - Page 165

161
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: 9HZ
B1EP1E7D
B1EP1E6D
Checks.
ESSENTIAL: Just prior to refitting, proceed to the checks as below.
Check:
- That the rollers and the coolant pump pulley turn freely (without play and without tight spot).
- That there are no signs of oil leaks (at the crankshaft and camshaft seals).
- That there are no leaks of coolant fluid (at the coolant pump).
- That the track of the target of the engine speed sensor (14) is not damaged or scratched.
Replace any components that are defective (if necessary).
Refitting.
Fit the timing belt on the crankshaft pinion.
Position the belt on the guide roller, belt well tensioned.
Refit:
- The timing belt protector (13).
- The engine speed sensor (14).
Reposition the timing belt, strip «f» well tensioned, in the following sequence:
- Guide roller (16).
- Camshaft pulley (20).
- Fuel high pressure pump pulley (19).
- Coolant pump pulley (17).
- Tensioner roller (18).
C5
Angl.T3-page032-190-2005 4/02/05 15:15 Page 161