D/I Mux III User’s Manual Appendix F. MIB II and DS1 MIB Group Names and Objects
238
Table F-2. DS1 MIB (RFC 1406) Groups and Objects
Group/Object Description
DS1 Near End Group
dsx1ConfigTable
The DS1 Configuration table.
dsx1ConfigEntry
An entry in the DS1 Configuration table.
dsx1LineIndex
This object is the identifier of a DS1 Interface on a
managed device.
dsx1IfIndex
This object’s value is equal to the value of ifIndex
from the MIB II Interface table (RFC 1213).
dsx1TimeElapsed
The number of seconds that have elapsed since the
beginning of the current error-measurement period.
dsx1ValidIntervals
The number of previous intervals for which valid data
was collected.
dsx1LineType
This variable indicates the variety of DS1 Line
implementing this circuit.
dsx1LineCoding
This variable describes the variety of Zero Code
Suppression used on the link, which in turn affects a
number of its characteristics.
dsx1SendCode
This variable indicates what type of code is being
sent across the DS1 interface by the device.
dsx1CircuitIdentifier
This variable contains the transmission vendor's
circuit identifier, to facilitate troubleshooting.
dsx1LoopbackConfig
This variable represents the DS1 interface loopback
configuration.
dsx1LineStatus
This variable indicates the interface Line Status.
dsx1SignalMode
‘None’ indicates that no bits are reserved for
signaling on this channel.
‘RobbedBit’ indicates that T1 Robbed Bit Signaling is
in use.
‘Bit-Oriented’ indicates that E1 Channel Associated
Signaling is in use.
‘MessageOriented’ indicates that Common Channel
Signaling is in use either on channel 16 of an E1 link
or channel 24 of a T1.
dsx1TransmitClockSource
The source of Transmit Clock.
dsx1Fdl
This is the facilities data link, and is the sum of the
capabilities. ‘Other’ indicates that a protocol other
than one following is used.
dsx1CurrentTable
The DS1 Current table.
dsx1CurrentEntry
An entry in the DS1 Current table.
To Next Page
Loading...