Chapter 5: System operation
Use the SBU web interface 181
5555
Set data limits
You can set a limit for the use of data services with the AVIATOR 700
system. You either specify a maximum number of MB for the standard data
connection, and/or a time interval from start to end for a streaming
connection.
If you have entered the call charges in the menu Call charges, the system
automatically calculates and displays the maximum charges for your data
sessions.
Once the entered limit is reached, the connection is automatically stopped.
This is recorded in the menu CALL containing a call log in which you can
see information on standard and streaming data sessions. To continue
using the data services you must start a new connection by clicking on the
desired connection on the Dashboard.
To set data limits, do as follows:
4. From the left navigation pane in the ADMINISTRATION page, select
Data limits.
5. Select the services to close automatically after a fixed amount of data
or period of time.
For Standard data type in the number of mega bytes (MB) allowed.
For streaming classes select a period of time from the drop down list.
6. Click Apply to save the settings.
Thrane & Thrane A/S does not take responsibility for the
correctness of the estimated charges. This calculation is only a
rough estimate of the charge, based on the tariff entered by the
user. Also, the airtime provider may have different methods of
calculating the charge.
If you set a data limit for the Standard data connection,
automatic activation of the Standard data connections is disabled
for all network user groups.
To Next Page
