COBHAM AVIATOR 700 - How to Make Calls from the Auxiliary Handset

Chapter 3: Calls, faxes and SMS
76 Operate the handsets
How to make calls from the Auxiliary
Handset
Before making a call, make sure you hear a dial tone in the handset.
Making a call from an Auxiliary Handset connected to an analogue POTS
phone interfaces is done in the same way as a call from a standard
telephone, but always with the prefix 00 and
U after the number to
signal to the terminal, that the number is complete.
Example: To call Cobham SATCOM VA (+1 757 463 9557) first establish
a connection by pressing
I or taking the handset off the
cradle. Then press the following keys on the phone:
TTJPNPMOLRNNPU
How to make Internal calls see To make local phone calls (SDU) on
page 39.
To take a call
Taking a call to the Auxiliary handset can be done in two ways:
• If the handset is in the cradle, take the handset from the cradle to take
the call.
• If the handset is out of the cradle, press
I to take the call.
To store a phone number
The Auxiliary handset can store up to 10 phone numbers, in memory
location 0 to 9. The
A, B and C keys can be used for accessing
memory location 1, 2 and 3, whereas the other locations are accessed using
the MEM key followed by the number of the location.
To store a number using A, B and C, d, do as follows:
1. Press
I or take the handset off the cradle.
2. Press
G.
3. Enter the phone number you want to store, including country code.