Chapter 5: System operation
Use the SBU web interface 183
5555
Remote management and activation
Prepare the AVIATOR 700 for remote management
1. Verify that the AVIATOR 700 is correctly set up for this feature. How to
set up this feature is described in the Installation and Maintenance
Manual.
2. Activate a data connection in one of the following ways:
• Remote activation with SMS.
• Automatic activation of a data connection (not remote).
• Manual activation of a data connection (not remote).
3. Note the system’s external IP address, found in one of the following
ways:
• Unmanned SMS activation: You will receive an SMS with the IP
address when the system is powered up and operational.
• Connect a computer locally to the system and start the web
interface. The IP address of the system is shown in the Dashboard
under ONGOING DATA SESSIONS (in parenthesis).
This is the IP address you must use to access the system remotely.
If Static IP address is included in your airtime subscription, we
recommend using this IP address for the system in order to provide
easy access to the system.
Note that only the SBU of the AVIATOR 700 can be accessed
remotely.
Some setup tasks must be done on the SBU before being able to
use the remote function. These tasks are described in the
following sections.
To Next Page
Loading...