Chapter 2: Get started
Connect a computer 27
2222
Connect a computer
PC setup — before you start
For the LAN or WLAN interface to work without any further setup, the
connected computer or IP device must be set up to obtain an IP address
and a DNS server address automatically. This is usually the case for most
PCs. If you are in doubt you can check your PC, see the step-by-step
procedure how to do this in IP address and DNS server address setup on
page 166.
Internet, e-mail, etc.
With SwiftBroadband the cabin applications e-mail, Internet and intranet
access, VPN, etc. are available. The connection type recommended for
these applications is the Standard data connection, which is also the default
setting. For background information on the Standard data connection see
Packet switched service on page 20.
Depending on how your system was set up initially there are two scenarios
that may be applicable when you use a data connection to access the
Internet, e-mail etc.:
To avoid unintended use of bandwidth, e.g. automatic
software updates, see Unintended use of bandwidth on
page 107 for information how to set up your computer. It is
recommended to disable the feature for automatic PC
software update in your computer.
Standard data
connection
Benefits Drawback
Automatic start
(system default)
Plug-and-play Risk of unintended use of
costly airtime, e.g.
Windows update
downloads, frequent
check for new mail etc.
To Next Page
Loading...
