Chapter 5: System operation
160 MCDU operation
typically configured during the installation of the system. For further
information see the AVIATOR 700 Installation and Maintenance
Manual.
TECHNICAL
TECHNICAL is for internal use only.
RESET
To reset (i.e. power cycle) the AVIATOR 700 system including the SBU, do
as follows:
1. Enter RESET view.
2. Select ACCEPT.
This operation will restart the satcom. The operation will take several
minutes.
STATUS menu
In the menus listed in the STATUS view you can find a large set of
AVIATOR 700 status information:
• LOGON shows which services are logged on.
• SERVICES shows which services are ready for use.
• CHANNELS shows which channels are in use and their respective signal
strength.
• NAV DATA shows detailed input from the external navigational source.
• IDS displays the serial numbers and ICAO address of the SDU.
• SW VERSION shows the software version and certification level of the
SDU and connected Full Feature handsets.
• LAN shows the status of the SDU LAN connection.
• ACTIVE ERRORS lists the active essential errors.
• ERROR LOG contains logs from previous power cycles.
To Next Page
