COBHAM AVIATOR 700 - AVIATOR 700 System Parts

Chapter 1: Introduction
System description 9
1111
Introduction
PBX telephone exchanges
The AVIATOR 700 system has two built-in independent PBX units:
• PBX in the Satellite Data Unit (SDU)
• PBX in the SwiftBroadband Unit (SBU)
See the overview in AVIATOR 700 Interfaces on page 6 for information on
which types and how many phones can be connected to each PBX. You can
route calls to handsets connected to the same PBX (SDU or SBU).
You can also connect the AVIATOR Wireless Handset.
If you have an IP phone or Smart Phone that has a SIP client, you can use
the integrated SIP server of the SBU. For instructions see To set up a SIP-
enabled wireless IP handset (SBU) on page 81.
AVIATOR 700 system parts
The AVIATOR 700 system comprises the following parts:
• TT-5035A Satellite Data Unit (SDU) and TT-5014A High Power
Amplifier (HPA)
• TT-5040A SwiftBroadband Unit (SBU)
• Handsets
• Multifunction Control and Display Unit (MCDU) (optional)
• Web interface for SBU control
Note
Call routing between the two PBX units is not supported.
The devices in the cabin must be connected to the correct unit,
the Satellite Data Unit (SDU) or the SwiftBroadband Unit (SBU), to
support the individual services.
A call incoming on the SDU can be routed to a handset marked
SDU, a call incoming on the SBU can be routed to a handset
marked SBU.