Chapter 3: Calls, faxes and SMS
60 Use a phone or fax machine (SBU)
Send or receive a fax message (SBU)
Delay before time-out
When sending or receiving fax messages over a satellite connection, the fax
units at each end of the transmission line must be capable of handling
longer delays without timing out. Some fax machines have an Overseas
mode, which enables the unit to handle the long delays. Make sure that
your fax machine is set to allow long delays before time-out.
To send a fax message (air to ground) (SBU)
The fax machine must be connected to the Phone/Fax interface or the
ISDN interface of the system. See the AVIATOR 700 Installation and
maintenance manual for further details.
3.1 kHz Audio must be used for an analog fax machine. See To select the
default outgoing call type (SDU) on page 35.
UDI must be used for an ISDN G4 fax machine, refer to the AVIATOR 700
Installation and maintenance manual for details how to configure the ISDN
interface.
To send a fax from a fax machine connected to the system, dial
00 <country code> <phone number> #
Example: To send a fax to Cobham SATCOM VA (+1 757 463 9581), dial
00 1 757 463 9581 #
Before sending or receiving fax messages, make sure both
fax units are in “Overseas” mode.
In case the default setting in the web interface is not 3.1 kHz
Audio, dial 2 * before the number, to force the connection to use
3.1 kHz Audio for fax use. For further information, see To override
the default outgoing call type (SDU) on page 36.
To Next Page
Loading...
