Chapter 3: Calls, faxes and SMS
36 Use a phone or fax machine (SDU)
To override the default outgoing call type (SDU)
To override the default setting for a specific outgoing call, dial the following
prefix before the number you want to call or fax:
• 00: Use default call type
• 01: Use default fax type
• 10: Force the call type to H+ (Classic Aero) (Standard voice)
• 11: Force fax type H+ (Classic Aero)
• 20: Force call type HSD (Swift64) (High-quality voice)
• 21: Force fax type HSD (Swift64)
Example: To call Cobham SATCOM VA, that has the country code 1 and
the phone number 7574639557, forcing the connection to use
Standard Voice, dial
10 1 7574639557 followed by # if calling from an analog or
ISDN phone, or off-hook key if calling from an AVIATOR
Wireless Handset.
Phone numbers for incoming 3.1 kHz Audio and Standard Voice
The phone numbers are listed in the documentation from your service
provider.
For information on how to make a call to the system, see Phone number
for a call (ground to air) (SDU) on page 38.
To select the incoming call type (SDU)
This is set up during initial configuration of the system. For further
information, see the AVIATOR 700 Installation and maintenance manual
and the online help of the Aero-SDU Configuration Program.
This will not change the default call type, only the type used for
this call.
The call type you are using must be selected in the Aero-SDU
Configuration Program.
To Next Page
Loading...
