Chapter 2: Get started
28 Connect a computer
Check with your system responsible whether your system is set up to
automatic activation of a standard data connection (plug-and-play).
To access the Internet or use your e-mail program do as follows:
1. Switch on your PC or Smart Phone.
2. For LAN: Connect your LAN cable (standard Ethernet) between the
network connector on your computer and one of the LAN connectors
installed in the aircraft.
For WLAN: Check that the WLAN icon in the status bar of your
operating system indicates that the WLAN connection has been
established.
3. Start your application, e.g. Internet browser or e-mail program.
If you cannot establish a connection, the automatic activation of a
standard data connection may be disabled in your system. Then you
can start a connection manually, you do this in the built-in web
interface. To learn more about the web interface see Use the SBU web
interface on page 164.
How to establish a connection manually see Start or stop a Standard
connection on page 110 or Start or stop a Streaming connection on
page 111 for detailed instructions.
If you want to change the start-up mode of the standard data
connection contact your system administrator to change the setting in
your network user group for Automatic activation to Enabled or
Disabled. This is described in detail in the AVIATOR 700 Installation
and maintenance manual.
Manual start from the
web interface
(This must be configured
during initial
configuration.)
Efficient
bandwidth
usage
You must start the web
interface at
http://192.168.0.1 and
click once to start a
connection.
Standard data
connection
Benefits Drawback
To Next Page
Loading...
