Chapter 3: Calls, faxes and SMS
Use a phone or fax machine (SBU) 47
3333
Example: If a fax is always connected to the same Phone/Fax interface
you can set this interface to 3.1 kHz Audio only. This means
that if an incoming Standard Voice call is received, this
interface will not ring. For details how to set up the interfaces
see the AVIATOR 700 Installation and maintenance manual.
When connecting a G4 fax or a modem to the ISDN interface in the
AVIATOR 700 system you must use UDI.
To select the default outgoing call type (SBU)
This is typically set up during initial configuration of the system.
You can set the default outgoing call type in the web interface. For details
how to access the web interface see Access the web interface on
page 167. To select the default call type for outgoing calls, do as follows:
• ISDN: Select the call type under SETTINGS > ISDN.
• Phone/Fax: Select the call type for each port under SETTINGS >
Phone/Fax.
• AVIATOR Wireless Handset: Select the call type for each handset
under SETTINGS > IP handsets > Call settings.
For further information, see the AVIATOR 700 Installation and
maintenance manual.
To override the default outgoing call type (SBU)
To override the default setting for a specific outgoing call, do as follows:
•To use Standard Voice for the call, dial 1* before the number.
•To use 3.1 kHz Audio for the call, dial 2* before the number.
Example: To call Cobham SATCOM VA that has the country code 1 and
the phone number 7574639557, forcing the connection to use
Standard Voice, press 1* 00 1 7574639557 followed by # if
calling from an analog or ISDN phone, or off-hook key if calling
from an IP handset.
This will not change the default call type, only the type used for
this call.
To Next Page
Loading...
