Chapter 3: Calls, faxes and SMS
50 Use a phone or fax machine (SBU)
Dial 00 <Short Dial> followed by # or off-hook key.
Example: To call entry number 4 in the phone book,
dial 004 followed by # or off-hook key.
• Manual Dial. Dial 00 <country code> <phone number> followed
by # or off-hook key.
Example: To call Cobham SATCOM VA that has the country code 1
and the phone number 7574639557 press 00 1
7574639557 followed by # or off-hook key.
• Call from phone book or call log (only AVIATOR Wireless Handset).
• Enter the phone book of the IP handset, scroll to the wanted number
and press the off-hook key, or
• press the off-hook key from the main screen to display the latest
calls in the call log. Then scroll to the wanted number and press the
off-hook key again.
Note that this is the call log of the IP handset, not of the system.
If there was an error establishing the connection, refer to SBU errors on
page 198.
If you are using the IP handset, the handset may show an error message.
Depending on the type of error, the web interface may also show an error
message. See Event log and self test on page 199.
To receive a call (SBU)
By default, all devices connected to the analog phone interface and the
ISDN interface and the WLAN interface will ring when one of the mobile
numbers is called. Note, however, that this depends on the call type settings
for ISDN, AVIATOR Wireless Handset and analog phone made during initial
configuration of the system. For further details on how to set up the
individual interfaces see the AVIATOR 700 Installation and maintenance
manual and the documentation for your cabin installation. You can see the
current setting of the SBU interfaces in the web interface.
Maximum 4 digits are allowed. If the number is higher than
0099, only one zero should be added (example: 0199)
To Next Page
Loading...
