Horizon Starter Manual 1-1
Setting Up the Imager
1
Setting Up the Imager
To prepare for the Horizon imager installation, review the following
guidelines and requirements:
•
Select a location for the imager that meets the requirements
described in “Location Precautions” on page xxi in the Preface.
•
It is recommended that you use a UPS (uninterruptible power
supply) to protect the imager from voltage spikes and power
outages.
•
Contact field service representatives of any imaging devices or
image viewing workstations that will be used with the imager, to
ensure that they are available during the imager’s installation to
assist with setup and help troubleshoot potential problems.
Preparing for Installation
CAUTION
Make sure that the table or printer stand can support the weight of the
imager [approximately 66.7 kg (147 lbs) with receive trays and three full supply
cassettes installed].
To Next Page
Loading...
