Horizon Starter Manual 1-15
Setting Up the Imager
After setting the imager’s IP address, you can load media cassettes
and, optionally, load a ribbon to support color prints. For more
information about how to load media, refer to “Inserting or
Changing Cassettes” on page 3-4 and “Changing the Ribbon
(ChromaVista)” on page 3-7.
If you have to ship the imager for any reason, you must use the
original imager box and packing materials. If you do not have the
original box and packing materials, contact your Codonics
representative.
1. If a ribbon is in the imager, remove it. For more information,
refer to “Changing the Ribbon (ChromaVista)” on page 3-7.
2. Make sure the top cover is closed and the receive trays are
inserted.
NOTE:
The top cover must be closed
and
the receive trays must be inserted for the thermal
print head to park. If either the top cover is open or the receive trays are not inserted, the
imager will display a message indicating that it cannot be shut down until the condition is
corrected.
3. Power off the imager. For more information, refer to “Powering
Off the Imager” on page 2-7.
4. Remove the receive trays.
Loading Media
Preparing the Imager for Shipment
8
To prepare the
imager for
shipment
3
To Next Page
Loading...
