Horizon Starter Manual 6-1
Default Print Job Settings
6
Default Print Job
Settings
Every print job has parameters associated with it that control how
the job is to be processed (for example, media size and type,
scaling, gamma, contrast, and so on).
The Horizon imager has a complete set of
default settings
for every
media type/size, sheet, and image parameter of a print job. The
default settings can be viewed and changed through the control
panel. Default settings are applied when no other source, such as
the application or PostScript driver, supplies settings.
Most DICOM applications support some, if not all, image and sheet
settings. Commonly-supported settings include Dmin, Dmax, and
trim lines.
Since any setting that appears in the control panel also appears in
the PostScript driver, it is usually more convenient to change
settings in the driver rather than in the control panel of the Horizon
Imager.
Refer to the
Horizon Imager Technical Manual
for a summary of
the print job parameters that can be changed.
CAUTION
Use caution when changing the imager default settings. Changes could
affect prints made by other users. Use Job Settings to avoid affecting other users.
To Next Page
Loading...
