Horizon Starter Manual xix
Preface
This product is in conformity with the protection requirements of
EC Council directive 89/336/EEC on the approximation of the laws
of the Member States relating to electromagnetic compatibility. This
product satisfies the Class B limits of EN 55011. A declaration of
conformity with the requirements of the Directive has been signed
by the Director of Quality Assurance and Regulatory Affairs.
Safety Precautions
•
Never connect this imager to any outlet or power supply that has
a voltage or frequency different than that specified on the rear of
the imager.
•
When servicing the imager, always power it off using the
(power) key at the control panel, then turn the rocker switch
in the back
to the
0
(off) position, then unplug the imager.
•
Damage to the power cord may cause fire or shock hazard. When
unplugging the power cord, hold it by the plug only and remove
the plug carefully.
•
If the power cord needs to be replaced, replace it only with
another Codonics power cord manufactured specifically for your
imager’s power configuration.
•
If the imager is smoking or making unusual sounds, power off
and unplug the imager immediately.
•
Do not insert foreign objects of any kind into the imager; doing
so can constitute a safety hazard and cause extensive damage.
To Next Page
Loading...
