Horizon Starter Manual 1-9
Setting Up the Imager
2. Press the (power) key at the control panel.
NOTE:
Always use the key at the control panel to power on/off the imager. The power
rocker switch at the back of the imager should always be in the
1
(on) position, unless the
imager is being serviced or moved.
The control panel display shows startup messages as the imager
initializes. When the Status screen displays (shown below), the
imager is ready to receive images.
Cleaning the Platen Roller
Clean the platen roller after powering the imager on for the first
time. Refer to “Cleaning the Thermal Print Head and Platen Roller”
on page 7-3.
Supply
1: No cassette
2: No cassette
3: No cassette
Status OK
X
No sheets queued
3
To Next Page
Loading...
