1-14 Setting Up the Imager
5. To change the first octet, press the or key until the
number you want is displayed.
Hold these keys to cycle through numbers.
6. To select the next octet, press the key. (Press the key to
return to the previous octet.)
7. Repeat steps 5 and 6 until all four octets in the Base IP Address
have been defined. To save, press the key.
NOTE:
To exit the Network Addresses menu without saving your changes, press the
key. The previous menu in the hierarchy displays.
8. Press the or key to leave the Network Settings menu.
A message states that the imager will automatically reboot when
you press the key to exit the Main Menu.
9. Press the key to acknowledge the message.
10. When you are finished specifying the IP address and want to
exit the Main Menu, press the key.
Because the base IP address was defined, the imager reboots so
that it can be identified properly on the network.
NOTE:
You can reset the network settings to their default values at any time by selecting
the
Reset Network Settings
option in the Network Settings menu.
Specifying IP Addresses for Other Devices
on the Network
Just as you did for the Horizon imager, you must specify the IP
addresses for each of the other devices on the network. Refer to the
documentation or online help that comes with the device for
specific instructions.
For more information about IP addressing conventions, refer to the
Horizon Imager Technical Manual
.
S
T
X W
ENTER
3
CANCEL
CANCEL
W
MENU
ENTER
MENU
3
To Next Page
Loading...
