Horizon Starter Manual 1-13
Setting Up the Imager
3. With the
Network Settings
option selected, press the key.
The Network Settings menu displays. Note that the current
settings are displayed in square brackets.
4. Select the
Addresses
option, then press the key.
The Network Addresses menu displays. Note that bold square
change
brackets are displayed around the first IP address octet
value of the Base IP Address. The bracketed portion of the
address is the portion that can currently be changed.
NOTE:
The Horizon imager can have more than one IP address assigned to it. For more
information about assigning multiple IP addresses, refer to the
Horizon Imager Technical
Manual
.
Network Settings
Network Settings
Speed [Auto Sense]...
XAddresses...
Reset Network Settings
Set network addresses of this
Imager.
Press MENU to exit menus
Network Addresses
Base IP Address:
[0].0.0.0
Gateway:
0.0.0.0
Subnet Mask:
255.255.255.0
Number of IP Addresses: 1
Set base IP address
Old value: 0.0.0.0
UP/DOWN to alter octet, LEFT/RIGHT
to change octets
Press MENU to exit menus
ENTER
ENTER
3
To Next Page
Loading...
