Horizon Starter Manual 4-3
Printing from DICOM
Applications
How you select a Horizon imager as a destination, then send a print
job to it, is unique to your specific DICOM user application. For
details, refer to your key operator, DICOM user application vendor,
or the accompanying DICOM application documentation.
Specifying the Media Type and Size
Typically, you will set the media type and size to use for a given
print job from within the SCU DICOM application. However, if your
application does not support the correct size and type of media, you
have two options:
•
Use a System Job Settings file (listed in Appendix B) as the Called
AE Title. This will force the print job to the correct media size and
type. This is useful when only the media needs to be specified
via AE title.
•
Use a Custom Job Settings file that specifies the desired media
type/size. Custom Job Settings are most useful when several print
Job Settings must be controlled at the printer rather than at the
DICOM application.
Occasionally it is possible that there is a setting supported by the
Horizon imager that cannot be specified in your DICOM
application. Using the imager’s
Job Settings
feature, you can work
around this limitation.
Sending a DICOM Print Job
Using Job Settings Files with DICOM
To Next Page
Loading...
