InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
13.1.1.25 Value: BusL V
BusL voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.
13.1.1.26 Value: BusL V L1-L2
BusL voltage between phase L1 and phase L2.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.
13.1.1.27 Value: BusL V L2-L3
BusL voltage between phase L2 and phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.
To Next Page
Loading...
Need help?
General
