ComAp IGS-NT Series User Manual

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
212
13.1.1.28 Value: BusL V L3-L1
Group
BusL values
Units
V
Related FW
3.0
Description
BusL voltage between phase L3 and phase L1.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint VbL VT ratio.
13.1.1.29 Value: BusL curr L1
Group
BusL values
Units
A
Related FW
3.0
Description
BusL current in phase L1.
NOTE:
The ratio between the current measured at the input terminals and the
displayed current is adjusted by the setpoints BusLeftCTprim and
BusLeftCTsec.
13.1.1.30 Value: BusL curr L2
Group
BusL values
Units
A
Related FW
3.0
Description
BusL current in phase L2.
NOTE:
The ratio between the current measured at the input terminals and the
displayed current is adjusted by the setpoints BusLeftCTprim and
BusLeftCTsec.

ComAp IGS-NT Series Specifications

General

Brand	ComAp
Model	IGS-NT Series
Category	Controller
Language	English