USER MANUAL FOR mPICO SERIES
Copyright - refer to title page
1 GENERAL INFORMATION
The mPICO Series Digital Pico Repeater (hereinafter called “mPICO”) is designed for single/dual/triple
band network. It can wireless transmit, bi-directional amplify uplink and downlink signals and is designed
for eliminating communicational coverage blind spots.
mPICO is used in indoor locations where small-scale signal coverage for metropolitan environment is
desired (e.g., hotels, department stores and shopping malls, underground parking lots, convention
centres, arenas, etc.)
Characteristics of mPICO are as follows:
Uplink and downlink with digital carrier selective frequency can efficiently amplify BS signal and MS
signal.
Digital filter technique allows better filter function.
With both gain and frequency temperature automatic adjustment ensures equipment in a stable
operation.
With out-of-band suppression and supports automatic gain temperature compensation function
which can maintain regular operation among working temperature.
Local Operation and Maintenance Terminal (OMT): operating status and parameters can be set or
monitored by OMT locally.
Operation Maintenance Center (OMC): system working parameters and communication
configuration can be set or inquired remotely through the build-in modem. If alarm is generated, the
equipment will dial up to OMC automatically in the mode of SMS or PSD.
External Li-ion battery ensures that alarm information can automatically report to OMC in case of
equipment power failure.
The following figure shows the enclosure of the mPICO.
To Next Page
Loading...
