USER MANUAL FOR mPICO SERIES
Copyright - refer to title page
0.5 SAFETY NOTICES AND ADMONISHMENTS
This document contains safety notices in accordance with appropriate standards. In the interests of
conformity with the territory standards for the country concerned, the equivalent territorial admonishments
are also shown.
Any installation, adjustment, maintenance and repair of the equipment must only be carried out by trained,
authorized personnel. At all times, personnel must comply with any safety notices and instructions.
Specific hazards are indicated by symbol labels on or near the affected parts of the equipment. The
labels conform to international standards, are triangular in shape, and are colored black on a yellow
background. An informative text label may accompany the symbol label.
Hazard labeling is supplemented by safety notices in the appropriate equipment manual. These notices
contain additional information on the nature of the hazard and may also specify precautions.
Warning:
These draw the attention of personnel to hazards that may cause death or injury to the operator or others.
Examples of use are cases of high voltage, laser emission, toxic substances, point of high temperature,
etc.
Alert:
These draw the attention of personnel to hazards that may cause damage to the equipment. An example
of use is the case of static electricity hazard.
Caution notices may also be used in the handbook to draw attention to matters that do not constitute a
risk of causing damage to the equipment but where there is a possibility of seriously impairing its
performance, e.g. by mishandling or gross maladjustment. Warnings and Cautions within the main text do
not incorporate labels and may be in shortened form.
CAUTION: danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
Cautions:
Risk of explosion: if battery is replaced by an incorrect type. Dispose of used batteries according to the
instructions.
The repeater is allowed to be operated only with permission of the network operator. This equipment
needs professionals to install and debug accordingly, the installer need to pay attention to radiation effect
to human being through the permitted use distance. The device and the antenna for this device must be
installed to ensure a minimum separation distance of 1.8 meters or more from a person's body. The
maxim service antenna gain should be less than 10dBi.
The installer has to assure by constructive measures or warning labels that general public is not allowed
to get closer to the antenna hen the permitted use distance.
The socket-outlet shall be installed near equipment and shall be easily accessible.
The CE mark sticker can be found on one side of the carton.
End of Section
To Next Page
Loading...
