5 Configuration
32 / 80 GB October 2013
Three steps are necessary to do this:
1. Define switching on and off times.
2. Grant the enablement for timer control operation
in the menu "Controls".
3. Press the start key < I > (turn the compressor
on).
Example
A factory might work a 2-shift system where the
morning shift starts at 8 am (08:00) and finishes at
4 pm (16:00).
An evening shift might then start at 5 pm (17:00)
and finish at 1 am (01:00).
5 day working week; there is no weekend work.
The controller is programmed as follows for this:
•
The compressor starts at 07:50 a.m.
•
The compressor stops at 16:10 p.m.
•
The compressor starts at 16:50 a.m.
•
The compressor stops at 01:10 p.m.
5.5.3.2 Setting the start and stop times of the
compressor
The setting of the compressor start and stop times
is described using the previous example.
1
Tap the <Settings> tab.
–
The menu "Settings" appears.
2
Tap the <Timer Control...> button.
–
The menu "Timer Control" appears.
Timer Control
Select a Setting
Date and Time
Timer Start/Stop
Timer Pressure Band p2
Display / Adjust
Display / Adjust
OK
This page is to set the Timer Channel
only. The Timer for
Compressor Start/Stop or activating the
second Pressure Band must be enabled
within Setpoints Menu.
Fig. 5-24: Menu "Timer Control"
3
Tap button <Timer Start/Stop>.
–
The menu "Timer Start/Stop" appears.
Timer Start/Stop
Start/Stop Schedule
Select Setting Channel 1..8
OK
Channel 1
Channel 3
Channel 5
Channel 7
Channel 2
Channel 4
Channel 6
Channel 8
Off
Off
Off
Off
Off
Fig. 5-25: Menu "Timer Start/Stop" (condition after pro-
gramming)
The menu shows the overview of the timer control
channels.
Each timer channel controls one compressor start
time and one compressor stop time and enables
them to be applied to one or more days of the
week.
Program the compressor for the morning
shift
1
Tap button <Channel 1>.
– The input menu for setting start time, end
time and weekday appears.
Timer Start/Stop
Set Channel 1
Start
OK
Mo.
Tu.
We.
Th. Fr. Sa.
Su.
Delete Channel
Cancel
Stop
Day of the Week
07
50
16
10
Fig. 5-26: Input menu "Timer Start/Stop" for timer con-
trol channel 1 (condition after programming)
2
Press buttons <+> and <-> to set the start and
end times.
3
Tap button <Day of the Week>, to specify the
weekdays on which the time setting should be-
come effective.
Button <Delete Channel> causes all entries to
be discarded.
Data entry is cancelled by tapping the button
<Cancel>. The functionality previously allocated
to the timer control channel is used.
To Next Page
Loading...
Need help?
General
