Compaq PROLIANT ML370 Maintenance And Service Guide

Removal and Replacement Procedures 2-23
Power Switch with Cable and LED Indicators
To remove the power switch and cable assembly:
1. Perform the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Open the front bezel (tower model only). See “Front Bezel” earlier in this chapter.
3. Remove the small access panel. See “Small Access Panel” earlier in this chapter.
4. Remove the single T-15 screw securing the power switch to the chassis ➊.
5. Slide the power switch housing back ➋, then lift it out of the chassis ➌.
2
3
1
Figure 2-19. Removing the power switch with LED and cable

Compaq PROLIANT ML370 Specifications

General

Brand	Compaq
Model	PROLIANT ML370
Category	Server
Language	English