To shut down the combination puller/cutter, perform the stop-
ping procedure listed above. No additional steps are necessary
if the combination puller cutter is shut down for short period
of time. If the unit is shut down for an extended period of
time, puller belts can and do acquire 'set.' If this occurs, let the
puller run for 20-30 minutes before use. This should remove
any set from the belts.
SHUTTING
D
OWN THE
PULLER/CUTTER
WARNING: Never use any part of the
guard circuit or the rotary disconnect
to stop the combination puller/cutter.
This can cause damage to the equipment and
injury to personnel. Use the recommended pro-
cedure to assure safe stopping.
STOPPING THE
COMBINATION
PULLER/CUTTER
To safely stop the combination puller/ cutter:
Press Cut On/Off Softkey to Off to stop cutting
(Softkey text changes to off).
Press Stop Cutter button to disable the servo motor.
Remove extrudate from both puller and cutter.
Press the red Puller Stop button.
Turn the rotary disconnect to the off position.
Disconnect the power cord
if it is equipped with a
plug on the end.
Lock out the rotary disconnect.
Clean the lubricant reservoir
if you are shutting
down the combination puller/cutter for the day.
WARNING: Never turn off the rotary
disconnect first.
Doing so will turn off all power to the unit, and
the cutter will not be brought to a controlled
stop. For safe stopping, always follow the
sequence given above.
1
2
3
4
6
7
8
5
4-38 OPERATION
UGE048/1103 CSC Combination Puller/Cutter
To Next Page
Loading...