Consilium CFD5000 T/CM2.2 - Safety considerations; If a fire or fault alarm is flashing on the control panel

Table of contents
1 Introduction....................................................................................... 1
1.1 About this manual............................................................................. 1
1.2 References ......................................................................................... 2
1.3 Symbols used in the manual ............................................................. 2
2 Safety considerations ........................................................................ 3
2.1 If a fire or fault alarm is flashing on the control panel .................. 3
2.1.1 In case of a fire alarm..................................................................... 3
2.1.2 In case of a fault alarm................................................................... 3
2.1.3 Further instructions ........................................................................ 3
2.2 Precautionary measures ................................................................... 4
3 Fire Detection System ....................................................................... 5
3.1 System Description............................................................................ 5
3.1.1 Introduction.................................................................................... 5
3.1.2 Systems and Interfaces................................................................... 5
3.1.2.1 CCP Fire ....................................................................... 5
3.1.2.2 CFD5000 FDS - an extension of CCP Fire................... 6
3.1.2.3 CFD5000 FDS Subsystem ............................................ 7
3.2 System data........................................................................................ 9
4 Prerequisites for installation ............................................................ 11
5 Electrical Installation ....................................................................... 13
5.1 Recommended installation order...................................................... 13
5.2 Cabling and Electrical Installation .................................................. 13
5.2.1 EMC requirements ......................................................................... 13
5.2.2 Cable requirements ........................................................................ 15
5.2.3 Loop lengths................................................................................... 16
5.2.4 Loops.............................................................................................. 18
5.2.5 Cable types..................................................................................... 18
5.2.6 Protective earthings........................................................................ 18
5.2.7 Location of electrical equipment ................................................... 19
5.3 Electrical installation, central equipment ........................................ 19
6 Mechanical Installation.................................................................... 21
6.1 Recommended installation order...................................................... 13