Consilium CFD5000 T/CM2.2 - Electrical installation, central equipment

Installation & Commissioning Manual 4Prerequisites for installation
5100607_CFD5000 T - CM2.2_Installation & Commissioning Manual_T_EN_2023_F
11
4 Prerequisites for installation
CAUTION!
The installation of the fire detection system must be performed by trained personnel
according to applicable rolling stock requirements.
CAUTION!
It is highly important to eliminate or reduce any high external electromagnetic
interference which can have a negative effect on the loop communication.
Make sure that cabling is carried out according to international rules and regulations.
CAUTION!
It is strongly recommended to use halogen free cables for loop-lines and connections
to external systems.
The different parts of the system should be installed and set up as stipulated in the
project specific documents and drawings.
The cables must be tested separately before the loops are connected to the loop
module. This eliminates any problem with the cable and electrical installation of
the loop units.
CAUTION!
Do not remove the protective cover from the detector until all paint work and
polluting (dusty) activities are finished and the area has been cleaned.
After installation: Be sure to remove all covers before the fire detection system is put
into operation.