Consilium CFD5000 T/CM2.2 - Fire Detection System; System Description

Table of contents
6.7.2.3 Dismounting of modules on a DIN rail......................... 33
6.7.3 DIN rail module support ................................................................ 33
6.7.3.1 General information ...................................................... 27
6.7.3.2 Mounting of DIN rail module support .......................... 34
6.7.3.3 Dismounting of DIN rail module support..................... 34
6.7.4 SLZ-2 DIN carrier.......................................................................... 34
6.7.4.1 General information ...................................................... 27
6.7.4.2 Mounting of SLZ-2 DIN carrier ................................... 35
6.7.4.3 Dismounting of SLZ-2 DIN carrier .............................. 35
6.7.5 DCDC converter ............................................................................ 36
6.7.5.1 General information ...................................................... 27
6.7.5.2 Mounting of MTM PCMDS DCDC converter ............. 36
6.7.5.3 Dismounting of DCDC converter ................................. 37
7 Pre-commissioning............................................................................ 39
7.1 Inspection .......................................................................................... 39
7.2 Test the loop cable ............................................................................. 40
7.3 Check the loop units.......................................................................... 44
8 Commissioning.................................................................................. 45
8.1 Commissioning requirements ........................................................... 45
8.1.1 Prerequisites for commissioning.................................................... 45
8.1.2 Proof test ........................................................................................ 45
8.2 Loops (Control Panel CM2.2) .......................................................... 46
8.2.1 Central status.................................................................................. 46
8.2.2 Verification of Loops ..................................................................... 46
8.3 Setting address and layout on Repeater M4.3.................................. 47
8.4 Testing of System Parts (Control Panel CM2.2) .............................. 48
8.4.1 Prerequisites for testing.................................................................. 48
8.4.2 About testing.................................................................................. 49
8.4.3 Recommended test equipment and procedures.............................. 49
8.4.3.1 Approved test equipment .............................................. 49
8.4.3.2 Heat detectors................................................................ 49
8.4.3.3 Smoke detectors ............................................................ 50
8.4.3.4 Aspirating smoke detectors........................................... 51
8.4.3.5 Flame detectors ............................................................. 52
8.4.3.6 Manual Call Points........................................................ 52
8.4.4 Test the Control Module Display................................................... 53