Coretec BS Series - 6 Installing Lines; Load Cell I;F(CN31); Origin Sensor I;F(CN32); MR-J3 A Parallel I;F(CN33)

BS Controller for AC SERVO PRESS
Instruction Manual Ver1.08
BS-M3A-1B
- 21 -
6.
Installing lines
6.1.
Load cell i/f(CN31)
It is used for the communication with strain gauge amplifier. The signal level
is an equivalent for RS-422. There is no necessity for connection in the system
without a load cell.
Cable type：CBSLC-**M(Basic Cable)
Cable type：JCBSLC-**M(Joint Cable)
6.2.
Origin sensor i/f(CN32)
An origin sensor is connected. Although, as for this system, absolute encoder
specification is also prepared, all tools are equipped with the origin sensor for
the initial position setup.
Cable type：CBSGS-**M
6.3.
MR-J3A parallel i/f(CN33)
It connects with CN1 of MR-J3A. The position detection pulse of a motor and
the position instruction pulse to MR-J3A are contained. In order to avoid the
influence of a noise, short wiring is recommended as much as possible.
Cable type：CBSPIF-**M
6.4.
Emergency stop(CN34)
An emergency stop SW is connected. The logic is normally closed. If it is made
opened, an emergency stop will be output to MR-J3A.