Coretec BS Series - Bit Assignment

BS Controller for AC SERVO PRESS
Instruction Manual Ver1.08
BS-M3A-1B
- 24 -
6.9.1.
Bit assignment
Input
Bit
number
Signal name
Contents
0
STOP
Program execution is interrupted, then a scram is carried
out. After performing speed zero for 0.2 seconds, it will be
in a servo off state.
1
RESET
Alarm release and judgment output reset.
2
ORIGIN
Origin is started. Original position information
disappears by start of origin.
3
START
Program execution is started.
4
USER_SEL
User output selection.
5
JOG_SPD1/U_IN0
Bit 0 of JOG speed specification binaries/user input 0,
are superposed.
When JOG_ENA is ON, JOG speed is
specified in four stages with the input bit 6. When
JOG_ENA is off, it becomes the user input 0.
6
JOG_SPD2/U_IN1
Bit 1 of JOG speed specification binaries/user input 1,
are superposed.
7
JOG_ENA
JOG operation is permitted. Moreover, the output bit 3 is
changed to BAT.ALARM.
8
PNO1/JOG+
The bit 0 of the binary value which specifies an execution
program number/+ Direction JOG are superposed. When
JOG_ENA is ON, JOG operation is carried out in the
direction of +.
9
PNO2/JOG-
The bit 1 of the binary value which specifies an execution
program number/- Direction JOG are superposed
. When
JOG_ENA is ON, JOG operation is carried out in the
direction of -.
10
PNO4
The bit 2 of the binary value which specifies an execution
program number.
11
PNO8
The bit 3 of the binary value which specifies an execution
program number.
12
PNO16
The bit 4 of the binary value which specifies an execution
program number.
13
SERVO_ON
Servo-on is directed to MR-J3A. In operation by PI/O,
unless it is in a servo-on state, a system does not operate
at all.*1
14
U_IN2
User input 2.
15
U_IN3
User input 3.
*1 On the tool operation screen and a program execution screen of BS Configurator,
SERVO_ON signal are ignored.