BS Controller for AC SERVO PRESS
Instruction Manual Ver1.08
BS-M3A-1B
- 64 -
Information, such as a tool type name and load cell proofreading value, is written in
BS tool. It will become alarm if the tool name different from the tool linked to BS
controller is set up.
About connection of BS controller and MR-J3A, there is no function to recognize the
capacity of MR-J3A in BS controller. Therefore, incorrect connection is not detected.
In multi-spindles composition, I ask sufficient consideration for connection of BS
controller, MR-J3A, and a motor of you.
To Next Page
Loading...