Coretec BS Series - 10 Starting; Starting Procedure of BS Controller; Attachment to Equipment; Wiring

BS Controller for AC SERVO PRESS
Instruction Manual Ver1.08
BS-M3A-1B
- 44 -
10.
Starting
10.1.
Starting procedure of BS controller
The outline procedure in the case of actually using BS controller is shown
below. The item which needs details is indicated after [2].
10.1.1.
Attachment to equipment
BS controller,MR-J3A and a tool are fixed to equipment.
10.1.2.
Wiring
Please wire with reference to a wiring diagram.
10.1.3.
Control power supply injection
Only a control power supply is switched on. Please refer Section7 Timing Chart
7-1 Power supply injection.
10.1.4.
Attachment of a backup battery
The backup battery for holding the contents of a setting is attached.
10.1.5.
Parameter setup of MR-J3A
The parameter of MR-J3A is set up. (It is required work only when MR-J3A is
purchased alone.)
10.1.6.
Parameter setup of BS
Tool type selection, a setup of a stroke limit, etc. are performed from exclusive
PC application BS Configurator.
10.1.7.
Re-starting of a power supply
After a setup of a parameter, a power supply is turned off at once and only a
control power supply is switched on again. If alarm has not occurred, AC power
supply is also switched on. When alarm has occurred, please remove a cause
with reference to troubleshooting.
10.1.8.
Check of a brake
When a mechanical brake is chosen as an option, it checks that a brake is
taken off in the state of operation.
10.1.9.
Check of an emergency stop
Please perform emergency stop operation and check that an emergency stop
operates.
10.1.10.
Origin
Large restriction is applied to speed and output load when origin has not been
completed.
10.1.11.
Build a program.
Build a program which suited the purpose using BS Configurator, and
transmit to BS controller.