Coretec BS Series - Page 3

BS Controller for AC SERVO PRESS
Instruction Manual Ver1.08
BS-M3A-1B
- 3 -
5.1.3. The interval with MR-J3A ............................................................................. 20
5.1.4. Noise Filter of MR-J3A .................................................................................. 20
6.
Installing lines ...........................................................................................................21
6.1. Load cell i/f(CN31) ................................................................................................. 21
6.2. Origin sensor i/f(CN32) ......................................................................................... 21
6.3. MR-J3A parallel i/f(CN33) .................................................................................... 21
6.4. Emergency stop(CN34) ......................................................................................... 21
6.5. RS-232C(CN4) ....................................................................................................... 22
6.6. RS-232C(CN5) ....................................................................................................... 22
6.7. RS-485(CN6,7) ....................................................................................................... 22
6.8. Ethernet(CN8) ....................................................................................................... 23
6.9. Parallel I/O (CN9) .................................................................................................. 23
6.9.1. Bit assignment ............................................................................................... 24
6.9.2. PIO connector pin assignment ...................................................................... 27
6.9.3. Wiring by the side of input ............................................................................ 27
6.9.4. Wiring by the side of output .......................................................................... 28
6.10. Control power supply (CN10) ........................................................................... 28
6.11. Backup battery（CN11） ...................................................................................... 28
6.12. Anybus .................................................................................................................... 28
6.13. Brake ...................................................................................................................... 29
6.14. Motor cable ............................................................................................................. 30
6.15. Encoder Cable ........................................................................................................ 30
7.
Timing Chart .............................................................................................................31
7.1. Power supply injection .......................................................................................... 31
7.2. Alarm reset ............................................................................................................ 31
7.3. Origin ..................................................................................................................... 31
7.4. JOG ......................................................................................................................... 32
7.5. Program execution ................................................................................................. 32
7.6. Program execution using Post Judge ................................................................... 33
7.7. Writing of a product name and a serial number ................................................. 34
7.8. Post Judge .............................................................................................................. 35
8.
Concept of stroke .......................................................................................................36
8.1. Semi closed loop ..................................................................................................... 36
8.2. Direction ................................................................................................................. 36