Crestron Electronics CP4N - Initial Setup; Access the Web Configuration Interface

Product Manual — Doc. 8559B 4-Series™ Control Systems • 103
Initial Setup
Use the following procedures to set up the 4-Series control system following installation.
Access the Web Configuration Interface
The control system may be monitored and configured using its web configuration interface. The
interface can be accessed via the control system IP address or the XiOCloud® service as
described in the following sections.
NOTE:The PRO4 can also be configured using its front panel LCDdisplay and navigational
pad.
IPAddress
To access the web configuration interface using the control system IPaddress:
NOTE:The control system ships with DHCPturned on. A DHCPserver is required to access
the web configuration interface via the control system IPaddress.
1. Connect the control system to the Ethernet network.
2. Locate the control system and its IP address on the network. The Device Discovery tool in
Crestron Toolbox™ software can be used to discover the control system IPaddress.
3. Enter the control system IPaddress into a web browser.
XiOCloud Service
The XiOCloud®service allows supported devices across an enterprise to be managed and
configured from one central, secure location in the cloud. The control system is configured to
connect to the service by default.
NOTE:An XiOCloud account is required to use the service. To register for an XiOCloud
account, refer to www.crestron.com/Support/Tools/Licensing-Registration/XiO-Cloud-
Registration-Room-Licenses.
To connect the control system to the XiOCloud service:
1. Record the MAC address and serial number that are labeled on the shipping box or the
control system. The MAC address and serial number are required to add the control
system to the XiOCloud service.
2. Log in to your XiOCloud account at portal.crestron.io.
3. Claim the control system to the XiOCloud service as described in the
XiOCloudUserGuide.