52 • 4-Series™ Control Systems Product Manual — Doc. 8559B
DIN-AP4 Specifications
Product specifications for the DIN-AP4 are provided below.
Product Specifications
Control Engine
Crestron 4-Series™ control processor; real-time, preemptive multithreaded/multitasking kernel;
Transaction-Safe Extended FAT file system; supports up to 10 simultaneously-running programs, native
.AVFramework™ software program
Communications
Ethernet 100 Mbps, autoswitching, autonegotiating, autodiscovery, full/half duplex,
industry-standard TCP/IP stack, UDP/IP, CIP, DHCP, SSL, TLS, SSH, SFTP (SSH
File Transfer Protocol), FIPS 140-2 compliant encryption, IEEE802.1X, SNMP,
BACnet and IP
1
, IPv4 or IPv6, Active Directory® service authentication, HTTPS
web server, HTTPS web browser setup and XiOCloud® client, SMTP email client
Cresnet® Network Cresnet master mode
USB Supports USB mass storage class devices via the front panel USB 2.0 host port,
supports computer console via the front panel USB 2.0 device port
RS-232/422/485 For 2-way device control and monitoring, COM port supports RS-232 up to
115.2k baud with software handshaking, one port also supports RS-422 or
RS-485 and hardware handshaking
IR/Serial Supports 1-way device control via infrared up to 1.2 MHz or serial TTL/RS-232
(0–5V) up to 115.2k baud
Memory
DDR3 SDRAM 1GB
Flash 8GB
Memory Card Supports SD and SDHC cards up to 32GB
External Storage Supports USB mass storage devices up to 1TB
Connectors and Card Slots
I/O1–8 (1) 9-pin 3.5mm detachable terminal block;
Comprises (8) Versiport digital input/output or analog input ports (referenced
to GND);
Digital Input: Rated for 0–24VDC, input impedance 20kΩ, logic threshold
>3.125V low/0 and <1.875V high/1;
Digital Output: 250mA sink from maximum 24VDC, catch diodes for use with
real world loads;
Analog Input: Rated for 0–10VDC, protected to 24VDC maximum, input
impedance 21kΩ with pull-up resistor disabled;
Programmable 5V, 2kΩ pull-up resistor per pin