200 • 4-Series™ Control Systems Product Manual — Doc. 8559B
l
deviceModel - The device type of the target client and the physical transport (refer to
Description of Manifest Parameters (on the facing page)). If this parameter is omitted,
the value will default to any.
l
controlSystemHostname - The host name or IP address of a control system that is
located in the client's IP table. If this parameter is omitted, the value will default to any.
l
deviceId - The IP ID, Cresnet ID, or RF ID of the device (in hexadecimal format). This
parameter can be displayed as a range (AA-ZZ) and/or as a list separated by commas
(A,B,…Z).
l
Path - Locates the path of a specific, generic device (without using a host name) within a
system. Each path node consists of the following:
o
A letter identifying the specific subnet where the device or parent device(s) is
located
n
C - Cresnet
n
E - Ethernet
n
R - RF
n
S - Slot
o
The subnet ID of the parent device
NOTE: The ID of the target device will always be specified in the device ID field
and not the path. Therefore, the last path node will only consist of a subnet
letter.
l
The path may consist of several parent devices. In this case, each element is delimited by a
colon.
l
Examples:
o
A control system with an Ethernet to Cresnet bridge (at IP ID 03) that contains an
EX gateway on Cresnet leg 1 (at ID A0) with a dim switch (at RFID 04) would have a
path of "E03:C1.A0:R" and a device ID property of "04."
o
An EX gateway located on Ethernet (at ID 05) has a path of "E" and a device ID of
"05."
The following top-level parameter is optional and is not necessary to complete the auto update
process:
l
logFolder - Each control system will create a result log file in this folder for each action.
The URL must be an SFTP location. For more information, refer to Results File (on
page207).
The actions to be taken by the client are defined by the filesToUpdate array:
l
filesToUpdate - The files associated with the action will be downloaded and installed in
the order they are listed. The following parameters are used to describe each entry in the
array and are required:
To Next Page
Loading...
