Crestron Electronics CP4N - Page 27

Product Manual — Doc. 8559B 4-Series™ Control Systems • 21
SNMPV3 Support
Built-in SNMP V3 support permits integration with third-party IT management software,
allowing network administrators to manage and control Crestron systems on the network in an
IT-friendly format.
BACnet Support
Native support for the BACnet communication protocol provides a direct interface to third-party
building management systems over Ethernet, simplifying integration with HVAC, security, and
other systems. Using BACnet, each system runs independently but communicates together on
one platform.
3
AppleHomeKit Integration
The MC4 supports integration with an Apple® HomeKit® technology system. Once the MC4 is
paired with a HomeKit system via SIMPLprogramming, a Crestron TSR-310 can be used to
control supported Apple devices. Apairing QRcode is affixed to the MC4 that makes it easy to
pair the control system directly to the Apple Home app.
4
PoENetwork Powered
Using PoE technology, the MC4 gets its operating power directly through the LAN wiring,
eliminating the need for a local power supply or dedicated power wiring. A PoE injector
(PWE-4803RU) connects in line with the LAN cable at a convenient location. Crestron PoE
switches (CEN-SW-POE-5 or CEN-SWPOE-16) may also be used to provide a total networking
solution with built-in PoE.
Versatile Mounting Options
The MC4 mounts conveniently to a wall, ceiling, or other flat surface. Its compact, surface-
mountable form factor fits easily behind a flat panel display, beneath a tabletop, or inside other
furniture, making it ideal for single-room systems. It can even be installed into an equipment rack
using the included rack ears or can be attached to a single rack rail.
Notes:
1. Modular Programming Architecture (MPA) on the MC4 requires the purchase of one SW-RMC3-10PROG license.
The license enables support for running up to 10 simultaneous programs on a single MC4. The license is not
required if only one program is run on the MC4. To obtain a license for the MC4, complete the Request for
SW-RMC3-10PROG License form. For questions, contact license@crestron.com.
2. The total range of an infiNET EX® wireless network is dependent on the placement and capabilities of each
network device. A mesh network topology is employed so every EX device on the network acts as a routing node
or expander, which relays the signals it receives on to other EX devices within range. This effectively extends the
total range of the network and provides multiple redundant signal paths for extra reliability. A maximum of six
hops across routing nodes is allowed, although a maximum of three is recommended. Battery-powered infiNET
EX devices only operate as leaf nodes and do not provide expander functionality. Up to 100 infiNET EX devices
are permitted, although best practices suggest a limit of 50. Up to 15 external gateways (CEN-GWEXER) may be
added to support additional devices (RF conditions allowing). Refer to the Installation and Setup of Crestron RF
Products Best Practices Guide for additional guidelines.